Setup automatically by using a push button



1  Hold down the [WPS] button on the access point (wireless router) until the security light flashes.

If you do not know where the [WPS] button is, or there are no buttons on the access point (wireless router), see the documentation provided with your access point (wireless router) for details.

2  Press the [Wi-Fi] button on the printer until the light and the light flash alternately (approximately 3 seconds).

3  Wait until the process ends.

When a connection is established, the light turns on.

Next »

When the connection failed


If the light and the light flash simultaneously, the printer is in a connection error status.
Press the [Wi-Fi] button to clear the error, check the following items, and then perform network setup again.
Check that the access point (wireless router) is turned on. If it is turned on, turn the access point’s (wireless router’s) power off and on again. Consider other users who may be using the network.
Disable the privacy separator on the access point (wireless router).
Place your printer close to the access point (wireless router).
Check that the access point (wireless router) supports WPS. If it does not support WPS, you cannot establish a network using Push Button Setup (WPS).
If the MAC address filtering function is enabled, register your printer’s MAC address to prevent your printer from being filtered. You can check the printer’s MAC address from the Network connection Report. See the documentation provided with the access point for registering.
Check that the Wi-Fi communication mode (IEEE802.11*) set for your access point (wireless router) matches the one supported by your printer. (*Display varies according to your location.)