Setup automatically by using a push button



1  Hold down the [WPS] button on the access point (wireless router) until the security light flashes.

If you do not know where the [WPS] button is, or there are no buttons on the access point (wireless router), see the documentation provided with your access point (wireless router) for details.

2  Press the button on the printer until the light and the light alternately blink (Approximately 3 seconds).

3  Wait until the process ends.

The light and the light will simultaneously light up when the connection is established. The light will be automatically turned off within 5 minutes.

Next »


If the light is off and the light is flashing, the printer is in a connection error status.
Press the button until the flashing light is off (Approximately 3 seconds). Check the following items, and then perform network setup again.
Check that the access point (wireless router) is turned on. If it is turned off, restart the access point (wireless router). Consider other users who may be using the network.
Check whether or not the DHCP function for the access point (wireless router) is enabled. If it is disabled, change it to enabled.
Place your printer close to the access point (wireless router).
Check that the access point (wireless router) supports WPS. If it does not support WPS, you cannot establish a network using Push Button Setup (WPS).
If the MAC address filtering function is enabled, register your printer's MAC address to prevent your printer from being filtered.
Check that the Wi-Fi communication mode (IEEE802.11*) set for your access point (wireless router) matches the one supported by your printer. (*Display varies according to your location.)